Danfoss VLT HVAC Basic Drive FC 101 Operating Manual page 44
Hide thumbs
Also See for VLT HVAC Basic Drive FC 101:
- Design manual (132 pages) ,
- Programming manual (124 pages) ,
- Quick manual (62 pages)
Table of Contents
Advertisement
Operating Guide | VLT® HVAC Basic Drive FC 101
Parameter
Option
Parameter 1-10
*[0] Asynchron
Motor Con-
struction
[1] PM, non-salient SPM
[3] PM, salient IPM
44 | Danfoss A/S © 2019.11
Default
Usage
[0] Asynchron
Setting the parameter value might change these parameters:
•
Parameter 1-01 Motor Control Principle.
•
Parameter 1-03 Torque Characteristics.
•
Parameter 1-08 Motor Control Bandwidth.
•
Parameter 1-14 Damping Gain.
•
Parameter 1-15 Low Speed Filter Time Const.
•
Parameter 1-16 High Speed Filter Time Const.
•
Parameter 1-17 Voltage Filter Time Const.
•
Parameter 1-20 Motor Power.
•
Parameter 1-22 Motor Voltage.
•
Parameter 1-23 Motor Frequency.
•
Parameter 1-24 Motor Current.
•
Parameter 1-25 Motor Nominal Speed.
•
Parameter 1-26 Motor Cont. Rated Torque.
•
Parameter 1-30 Stator Resistance (Rs).
•
Parameter 1-33 Stator Leakage Reactance (X1).
•
Parameter 1-35 Main Reactance (Xh).
•
Parameter 1-37 d-axis Inductance (Ld).
•
Parameter 1-38 q-axis Inductance (Lq).
•
Parameter 1-39 Motor Poles.
•
Parameter 1-40 Back EMF at 1000 RPM.
•
Parameter 1-44 d-axis Inductance Sat. (LdSat).
•
Parameter 1-45 q-axis Inductance Sat. (LqSat).
•
Parameter 1-46 Position Detection Gain.
•
Parameter 1-48 Current at Min Inductance for d-axis.
•
Parameter 1-49 Current at Min Inductance for q-axis.
•
Parameter 1-66 Min. Current at Low Speed.
•
Parameter 1-70 PM Start Mode.
•
Parameter 1-72 Start Function.
•
Parameter 1-73 Flying Start.
•
Parameter 1-80 Function at Stop.
•
Parameter 1-82 Min Speed for Function at Stop [Hz].
•
Parameter 1-90 Motor Thermal Protection.
•
Parameter 2-00 DC Hold/Motor Preheat Current.
•
Parameter 2-01 DC Brake Current.
•
Parameter 2-02 DC Braking Time.
•
Parameter 2-04 DC Brake Cut In Speed.
•
Parameter 2-10 Brake Function.
•
Parameter 4-14 Motor Speed High Limit [Hz].
•
Parameter 4-19 Max Output Frequency.
•
Parameter 4-58 Missing Motor Phase Function.
•
Parameter 14-65 Speed Derate Dead Time Compensation.
Programming
AQ275641848264en-000101 / 132R0078
Advertisement
Table of Contents
