PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-03 : Pan -> [ENTER]
duced by placing the output from different layers at different locations in the stereo
sound field. The parameters in this screen determine the position in the stereo sound
field in which the sound from each active layer will be heard (left to right).
selected layer is shown in square brackets on the upper display line.
Pan
64
3-1-03: PAN
3-1-03: PAN
In multi-layer performance combinations, interesting stereo effects can be pro-
PFM Pan [A] WN Flut1
3
+
ÿ -22ÿ +25ÿ 0ÿ
Pan (layer A)
The layer to be edited can be selected as described on page 50. The currently
Range: -31 ... +31
,
Use the [
] and [
the layer to be edited, then use the [-1/NO] and [+1/YES] keys to adjust the
pan position of the voice assigned to that layer. Minus values represent panning
to the left, and positive values represent panning to the right. "0" positions the
sound of the selected layer in the center of the stereo sound field.
The name of the currently selected voice is shown in the upper right corner
of the display ("--------" appears if the voice is turned off). An animated musi-
cal note appears to the right of voices that are on and active (i.e. not muted).
.
] keys (or the standard layer selection procedure) to select