3-2-13: Control Lfo - Yamaha TG500 Owner's Manual

PERFORMANCE EDIT MODE / 3: Full Edit. 3-2: Effect
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-2:Effect -> [ENTER]
-> [PAGE] -> 3-2-13 :Control LFO -> [ENTER]
trol. The TG500 has an independent effect LFO that is set up by the following pa-
rameters.
Wave (LFO waveform)
Speed (LFO speed)
Delay
88

3-2-13: CONTROL LFO

3-2-13: CONTROL LFO
All of the modulation-type effects — chorus, flanging, etc. — require LFO con-
PFM EF Ctrl LFO <Wave >
i
tr 0 0
Wave
Range: tri, dwn, up, squ, sin, S/H, 1tm
Determines the waveform of the effect LFO.
Range: 0 ... 99
Sets the speed of the effect LFO.
"0" is the slowest speed setting, producing an LFO speed of approximately
0 Hertz. The fastest setting of 99 produces an LFO speed of approximately 25
Hertz.
Range: 0 ... 99
Sets the delay time between the beginning of a note and the beginning of
effect LFO operation for the selected element.
The minimum setting "0" results in no delay, while the maximum setting of
"99" produces a delay of approximately 2.66 seconds before the LFO begins
operation (5.3 seconds before it reaches maximum depth).
Speed Delay