3-6-03: Midi Controller - Yamaha TG500 Owner's Manual

3-6-03: MIDI CONTROLLER 1 / 3-6-04: MIDI CONTROLLER 2
[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]
-> [PAGE] -> 3-6-03: MIDI Ctrl 1 -> [ENTER]
-> [PAGE] -> 3-6-04: MIDI Ctrl 2 -> [ENTER]
The parameters in these two screens set the maximum depth of modulation that
can be produced by "MC1" (MIDI Controller 1) and "MC2" (MIDI Controller 2).
MIDI controller assignments are made via the "UTILITY" mode "2:Controller" screen
— page 223.
Amod (Amplitude modulation depth)
Pmod (Pitch modulation depth)
3-6-03: MIDI CONTROLLER 1 / 3-6-04: MIDI CONTROLLER 2
VOICE EDIT MODE / 3: Full Edit. 3-6: Controller
VCE CTRL MC1 Depth<Amod>
(Mod.Whl.)
VCE CTRL MC1 Depth<EGBs>
è(Mod.Whl.) +2
Range: 0 ... 127
Sets the maximum depth of amplitude modulation (tremolo effects) applied
via MIDI controller 1 or 2.
A setting of "0" allows no amplitude modulation, while a setting of 127
results in maximum amplitude modulation depth.
When setting up the low-frequency oscillator to apply amplitude modula-
tion, this parameter must be set to a value other than "0" if amplitude modula-
tion is to be applied via MIDI controller 1 or 2.
Range: 0 ... 127
Sets the maximum depth of pitch modulation (vibrato effects) applied via
MIDI controller 1 or 2.
A setting of "0" allows no pitch modulation, while a setting of 127 results
in maximum amplitude modulation.
When setting up the low-frequency oscillator to apply pitch modulation, this
parameter must be set to a value other than "0" if pitch modulation is to be
applied via MIDI controller 1 or 2.
0
28 0é
Pmod
Fmod
Amod
0
0
EGBs
Cof
145