NEC NEAX2000 IPS System Manual page 42

CÔNG TY VIỄN THÔNG VIỆT PRO
Conditions for System Configuration
• The number of Remote Sites is a maximum of 30. However, since one Remote Site accommodates
multiple FP/AP cards generally, the actual number of Remote Sites should be 20.
[Series 3300 software required]
• The total number of FP/AP at Main Site and all Remote Sites should not exceed 64 including the MP
built-in FP, Virtual FP, and Virtual IPT.
[Series 3300 software required]
• The number of FP/AP accommodated at one Remote Site should be a maximum of eight including
the MP built-in FP.
• Remote Site can accommodate the following FP/AP/LT cards.
– FP
One MP built-in FP and two Virtual FP
– AP
CSH NOTE, BRT, 24PRT/30PRT (ISDN), 24DTI/30DTI (ACIS), 24CCT/30CCT (No. 7 CCIS)
NOTE: Be sure to mount CSH in the Site where CSI is installed. For North America, the CSH
and CSI cards for wireless system cannot be used at Remote Site according to UTAM
regulation.
– LT
IP-PAD (32IPLA-A/8IPLA)/16VCTA-A or 16VCTA, DLC NOTE, LC, COT, LDT, ODT, CSI
NOTE:
Attendant Console, Desk Console, Add-On Module, DSS/BLF Console are not mount-
able at Remote Site.
• Remote Site cannot accommodate the following FP/AP/LT cards.
– FP
FP card (CP15/CP19) is not mountable at Remote Site.
– AP
AP00 (SMDR), AP00 (DBM), ICH, CCH, DCH (ISDN/Q-SIG/Q931a), 4RSTB (MFC/T1-ANI/
E911), 4RSTC/D (Caller ID trunk), CS00 (ATI), CFTC (32-party conference), IPT
– LT
8RSTA/G (PBR) NOTE, ILC (ISDN Terminal), 4RSTE/F (Caller ID station), CFTA/B (6/10-party
conference), AMP, 4VCT, DK00, DAT
NOTE: Four-line built-in PBR on the MP card is available at Remote Site.
When Remote Site is IPS
stricted.
– PN-4LDTA (LDT), PN-4LLCB (LLC), PN-8PFTB (PFT)
• MP built-in FP must be set to each Remote Site.
Chuyên phân phối tổng đài NEC
DMR
, in addition to the above conditions, the following LT cards are re-
– 30 –
CHAPTER 1 GENERAL INFORMATION
http://vietpro.com.vn
SYSTEM CONDITIONS
ND-71503(E) Rev.5.0
9pch1001.fm
JANUARY/16/2004