NEC NEAX2000 IPS System Manual page 30

CÔNG TY VIỄN THÔNG VIỆT PRO
Card
This table shows the names and functions of circuit cards exclusively used in 2000 IPS.
For other legacy Control cards, Application Processor cards and Line/Trunk cards, refer to the Installation
Procedure Manual.
NOTE 1: PZ-M537 (EXPMEM) card is not required for the MP (PN-CP24-A/PN-CP24-B/PN-CP27-A)
card.
NOTE 2: PN-AP01 (AP01) card and PN-CC01 (ETHER) card cannot be mounted in 2000 IPS.
EQUIPMENT FUNCTIONAL
NAME
PN-CP24-A/ MP
PN-CP24-B
Chuyên phân phối tổng đài NEC
Card Name and Function
NAME
Main Processor Card
Provides LAN control function, System-based Device Registra-
tion Server (DRS), built-in FP, Virtual FP, built-in OAI, built-in
SMDR on RS-232C, built-in SMDR on IP*, built-in PMS on IP*,
Virtual IPT, Virtual CSH, 33 MHz PCI BUS, Memory (SDRAM
32MB, Flash ROM 9MB), TDSW (1024CH × 1024CH), 16-line
CFT, PB sender, Clock, 2-line PLO (receiver mode/source mode),
two RS-232C ports, 2-line DAT (Recording duration: Maximum
128 seconds), DK, 4-line PB receiver, Modem for remote mainte-
nance (33.6 Kbps), internal Music-on-Hold tone, BUS interface.
BUS interface functions as a driver/receiver of various signals,
adjusts gate delay timing and cable delay timing, monitors I/O Bus
and PCM BUS.
One card is required per system.
*: Series 3400 software enhancement
CHAPTER 1 GENERAL INFORMATION
FUNCTION
– 18 –
http://vietpro.com.vn
EQUIPMENT NAME AND FUNCTION
Continued on next page
ND-71503(E) Rev.5.0
SEPTEMBER/15/2004
9pch1001.fm