NEC NEAX2000 IPS System Manual page 177

CÔNG TY VIỄN THÔNG VIỆT PRO
E
CMA8 Assign the IPT number to the Destination Point
Code (DPC).
NOTE 1:
The Destination Point Code is used
to designate a terminating office in
the No. 7 CCIS network.
NOTE 2: Assign the DPC by CM8A Y=5000-
5255>168.
CMA7 Specify the connection type for Virtual IPTs in
Point-to-Multipoint connection.
Specify the release timer for Virtual IPT in
Point-to-Multipoint connection.
When the router provides DiffServ QoS, spec-
ify the DS code point (DiffServ code point) for
control packet.
NOTE: When this data is set, the TOS field precedence set by CMA7 Y=44 is ineffective.
If you want to validate the precedence set by CMA7 Y=44, set "CCC" (data clear) for
CMA7 Y=50.
CM20 Assign the first digit of remote office station
number to LCR Group 3.
CM8A Assign an Area Code Development Pattern
number to LCR Group 3.
Assign a Route Pattern number to the first digit
of remote office station number for the Area
Code Development Pattern number assigned
by CM8A Y=A000.
F
Chuyên phân phối tổng đài NEC
DESCRIPTION
Page 167
CHAPTER 3 SYSTEM DATA PROGRAMMING
CCIS VIRTUAL IPT DATA ASSIGNMENT
(1) 00001-16367: Destination Point Code
(2) 0-7: IPT No.
• Y=46
(1) 0-7: IPT No.
(2) 0: Point-to-Multipoint
• Y=45
(1) 0-7: IPT No.
(2) 000
001-127 : 1-127 minutes
NONE : Not released
• Y=50
(1) 0-7: IPT No.
(2) 00-3F: DS code point
• Y=0-3 Numbering Plan Group 0-3
(1) X: 1st digit of remote office station No.
(2) A129: LCR Group 3
• Y=A000
(1) 3: LCR Group 3
(2) 4000-4007: Area Code Development Pat-
• Y=4000-4007 Area Code Development
(1) X: 1st digit of remote office station No.
(2) 0000-0255: Route Pattern No. 000-255
– 165 –
http://vietpro.com.vn
DATA
: 30 seconds
(1 minute increment)
tern No. 0-7
Pattern No. 0-7
ND-71503(E) Rev.5.0
JANUARY/31/2003
9pch3001.fm