Adjusting The Chassis; Fig. 24 Fitting The Towbar; Fig. 25 Fitting The Towbar - KAESER M135 SIGMA CONTROL MOBIL Service Manual

Option sa
Fig. 24
Option sa
Fig. 25
6.4
Material
Precondition
58
6 Installation
6.4

Adjusting the chassis

Fitting the towbar
Overrun braking mechanism
1
Handle
2
Tie bar
3
Fitting the towbar
1. Remove all transport securing items (duct tape, foam pads) from the towbar components.
2. Undo the self-locking nut and remove the tie bar fixing bolt.
3. Bring the overrun braking mechanism into the horizontal position.
4. Push the tie bar end between the cheeks of the overrun braking mechanism and align the fixing
holes.
5. Push in the securing bolt, using light hammer blows if necessary.
6. Secure the bolt with the self-locking nut (see chapter 2.4.4 for tightening torque).
7. Take off the parking brake by pushing the lever down.
8. Pull out the securing pin and unscrew the locking lever to the stop.
9. Use the positioning handle to push the towbar to the required height.
10. Tighten the locking lever. Make sure the teeth in the adjustment joint mesh together.
11. Fully tighten the lever with a few hammer blows and insert the securing pin.
12. Pull on the parking brake again.
Adjusting the chassis
Pliers
Hard rubber hammer
The machine is shut down.
The machine is disconnected from the towing vehicle and safely parked.
Service Manual Screw Compressor
M135 SIGMA CONTROL MOBIL
Locking lever with securing pin
4
Parking brake lever
5
Fixing bolt and nut
6
No.: 9_6975 00 E