Xerox WORKCENTRE 7428 System Administrator Manual page 65

15. Select the Enabled check box next to Assign UPN (User Principal Name) if desired.
16. Click Reboot Machine.
Configure Remote Authentication for a Kerberos Server (Windows 2000 or Solaris)
1. Open your Web browser and enter the IP address of the printer in the address field. Press Enter to
open CentreWare Internet Services.
2. Click the Properties tab.
3. Enter the system administrator User Name and Password (default admin, 1111) if prompted.
4. Click the Security folder.
5. Click the Remote Authentication Servers folder. Enter your user name and password at the
prompt (default: admin, 1111).
6. Click Authentication System and pick Kerberos (Windows 2000) or Kerberos (Solaris) from the
drop down list. Click Apply, and click Reboot Machine.
7. Navigate back to the Remote Authentication Servers folder and click Kerberos Server.
8. Under Kerberso Server 1 (Default), enter the Primary Server Name / IP Address, Primary Port
Number (default port for a Kerberos server is 88), and the Domain Name (Realm name).
Note: Realm name for a Kerberos (Solaris) server should be in upper case. Example: YOURDOMAIN.NET
9. Enter the IP Address of the Primary Server.
10. The Secondary Server information is optional.
11. Enter details for up to 4 alternate Domain Controllers and backups, if required.
12. Click Apply, and supply the Administrator User name and password if prompted.
Configure Remote Authentication for SMB
1. Open your Web browser and enter the IP address of the printer in the address field. Press Enter to
open CentreWare Internet Services.
2. Click the Properties tab.
3. Enter the system administrator User Name and Password (default admin, 1111) if prompted.
4. Click the Security folder.
5. Click the Remote Authentication Servers folder. Enter your user name and password at the
prompt (default: admin, 1111).
6. Click Authentication System and pick SMB from the Authentication System Settings drop down
list.
7. Enter the Server Response Time-Out, and the Search Time-Out.
8. Select the Enabled check box next to Assign UPN (User Principal Name) if desired.
9. Click Apply, and click Reboot Machine.
10. Click SMB Server.
11. From the SMB Server Setup drop down menu, select your desired method. The selections include:
By Domain Name, and By Domain Name and Server Address / IP Address.
12. Enter the Domain name (up to 15 characters) in the Domain Name box, for every Domain
Controller specified. This entry is required regardless of the selection made from the SMB Server
Setup drop down menu.
Authentication
WorkCentre 7425/7428/7435
System Administrator Guide
65