Optional Ethernet Cable - Raven VSN Installation Manual

For nh sp 310f / miller 7310 front boom sprayers my19+

Hide thumbs Also See for VSN:

Table of Contents

CHAPTER 3

16. Install the protective covers using the hold-down bracket and M8 hardware.

FIGURE 20. Protective Covers Installed

17. Connect the 23-pin connection to the VSN.

18. Verify proper steering clearance is achieved by turning the tires back and forth and ensure no cables are tight.

19. Continue to verify proper steering clearance by raising and lowering the boom and ensure no cables are tight.

NOTE:

Ensure the installed radar brackets will not interfere with the valve stem of the tire when the wheel

rotates.

OPTIONAL ETHERNET CABLE (FOR USE IN THE EVENT OF WI-FI

FAILURE OR RESTRICTION)

1. Connect the blue/green Ethernet cable to the back of the VSN camera.

2. Route the Ethernet cable along the frame and up to the RS1.

3. Connect remaining end to the RS1.

FIGURE 21. RS1 Connection

VSN Installation Manual for NH SP 310F / Miller 7310 Front Boom Sprayers MY19+

Ethernet Port

Table of Contents