Hydraulic Installation Load Sense - Raven SBGuidance Auto Installation Manual

3.1 Hydraulic installation load sense

The manifold should be connected between the hoses
leading from the steering orbitrol to the steering
cylinder(s). To do so, the hoses must be disconnected,
preferably on an existing connection between a pipe
line and a hose.
Connect the hoses from the steering orbitrol to A1
and B1 on the manifold. Connect the hoses to the
steering cylinders to A and B on the manifold (Figure 3
and Figure 4).
Connect the pressure line, return line and the LS line of
the hydraulic pump to the P, T and LS of the manifold.
When needed refer to the hydraulic drawing of the
tractor to find the correct connections on the tractor.
Caution!:
If there are separate hydraulic systems with
separate oil tanks on the tractor, the manifold
must be connected to the system in which the
steering orbitrol and steering cylinder are
included in.
Tip!:
Mark the lines twice with 'A' and 'B', before
disconnecting them.
Tip!:
SBG Precision Farming can supplies hose kits for
different types of tractors. Please inquire about
the possibilities.
Page16/52 I SBG-Auto CAN-EN-Rev. A
SBGuidance Auto I Rev. A I CAN
Steering Cylinder(s)
Figure 3 Load sense connecting circuit.
Figure 4 Connections for the hydraulic load sense
manifold.