6
Notes about this Documentation
1
Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1
Validity of this Documentation
This documentation is only applicable to the I/O module 750-486
(4AI 0/4-20 mA, Ex i).
The I/O module 750-486 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus coupler or
controller.
Consider power layout of the WAGO I/O SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2
Revision History
Table 1: Revision History
Document
Version
1.0.0
1.1.0
1.1.1
1.1.2
Manual
Version 1.1.2
Device Version
Hardware Software
01
01
01
01
01
01
01
01
WAGO-I/O-SYSTEM 750
750-486 4AI 0/4-20 mA, Ex i
Description of Change
First issue
Changes in section "Commissioning".
Changes in section "Device Description"
Explosion Protection data.
Notes to the section "Configuration and
Parameterization using a GSD File" added.
Editorial revision
Editorial revision