Network Settings; Figure 25: Wbm "Configuration" Page - "Network Settings" Tab - WAGO 852-1322 Manual

852-1322/852-1328 Industrial Managed Switch
7.4.2

Network Settings

In this tab page, users may modify network settings of Internet Protocol version 4
(IPv4) for the WAGO industrial managed switch.
The Network Settings tab page is depicted in Figure "WBM "Configuration" Page
– "Network Settings" Tab". Inside the Network Settings box, the user can enable
Dynamic Host Configuration Protocol (DHCP) client inside the switch by checking
the DHCP box so that the switch can obtain IP address' setting automatically
from a DHCP server available on the user's local network. If the DHCP is
enabled, the rest of the fields will be disabled. Note that the user should consult
your local network administrator for information about the availability of DHCP
server. If the user prefers a static IP setting, then the user can proceed to enter
the IP Address, Subnet Mask, Gateway, and the Primary DNS. If the user set
gateway or DNS on this page, the industrial managed switch will not use the
gateway or the DNS from DHCP server. After entering the desired information,
please click [Submit] button to change the IP Setting.
Figure 25: WBM "Configuration" Page – "Network Settings" Tab
Configuration in the WBM 43
Manual
1.0.01