Security; Static Sak Setting; Figure 40: Wbm Page, "Security" - "Static Sak" Tab - WAGO 852-1322 Manual

Managed switch; 8 port gb; macsec/ 6 port gb; 2foc; macsec

Hide thumbs Also See for 852-1322:

Table of Contents

Configuration in the WBM

7.6

Security

7.6.1

Static secure association key (SAK) setting web page is shown in Figure "WBM

Page, "Security" – "Static SAK" Tab". Note that WAGO 852-1322 and 852-1328

support MACSec protocol on port number 7 and 8. To enable secure association

mode on industrial managed switch's port(s), first select one of the two ports from

the dropdown list under the Ports. Then, check the Enabled box. Then, enter the

Secure Channel Identifier (SCI) with a 16-digit hexadecimal number (i.e.,

0,1,2,...,a,b,c,d,e,f) and enter the Secure Association Key (SAK) with a 32-digit

hexadecimal number. Finally, click on the [Submit] button to update the setting

to one of the ports in the Static SAK Status table in the lower part.

Figure 40: WBM Page, "Security" – "Static SAK" Tab

Manual

1.0.01

852-1322/852-1328 Industrial Managed Switch

Table of Contents

Table of Contents

852-1328