Modbus Tcp; Figure 35: Wbm "Diagnostics" Page - "Modbus Tcp" Tab - WAGO 852-1322 Manual

Managed switch; 8 port gb; macsec/ 6 port gb; 2foc; macsec

Hide thumbs Also See for 852-1322:

Table of Contents

852-1322/852-1328 Industrial Managed Switch

7.5.2

Modbus TCP

WAGO's industrial managed switch can be connected to a Modbus network

using Modbus TCP/IP protocol which is an industrial network protocol for

controlling automation equipment. The switch's status and settings can be read

through Modbus TCP/IP protocol which operates similar to the Management

Information Base (MIB) browser. The switch will be a Modbus slave which can be

remotely configured by a Modbus master. The Modbus slave address must be

set to match the setting inside the Modbus master. In order to access the switch,

a Modbus Address must be assigned as described in this subsection. A Modbus

memory mapping table, which lists all the register's addresses inside the switch

and their descriptions, is provide in "Modbus Memory Map" table in the

"Appendix". Figure "WBM "Diagnostics" Page – "Modbus TCP" Tab" shows the

Modbus TCP tab page.

Figure 35: WBM "Diagnostics" Page – "Modbus TCP" Tab

Configuration in the WBM

Manual

1.0.01

Table of Contents

Table of Contents

852-1328