Technical Condition Of Specified Devices; Standards And Regulations For Operating The Industrial Switches - WAGO 852-1322 Manual

852-1322/852-1328 Industrial Managed Switch
Pos: 14. 7 /Alle Se rien (Allgem eine Mod ule) /Rechtlic hes, Allg emei nes/ Tec hnisch er Zust and der Ger äte - Üb ersch rift 3 un d In halt @ 3\ mod_ 122 106 044 610 9_2 1.docx @ 2 172 3 @ 3 @ 1
2.1.4

Technical Condition of Specified Devices

The devices to be supplied ex works are equipped with hardware and software
configurations, which meet the individual application requirements. These
modules contain no parts that can be serviced or repaired by the user. The
following actions will result in the exclusion of liability on the part of WAGO
Kontakttechnik GmbH & Co. KG:
• Repairs,
• Changes to the hardware or software that are not described in the
operating instructions,
• Improper use of the components.
Further details are given in the contractual agreements. Please send your
request for modified and new hardware or software configurations directly to
WAGO Kontakttechnik GmbH & Co. KG.
Pos: 14. 8 /Seri e 85 2 (E THERNET- Zub ehö r)/Wich tige Erl äut eru ngen /Nor men un d Richtlini en 8 52- xxxx - Ü be rschrif t 2 und Inhal t @ 3 \mo d_1 222 346 2394 53_ 21. docx @ 22 261 @ 3 @ 1
2.1.5 Standards and Regulations for Operating the Industrial
Switches
Please observe the standards and regulations that are relevant to installation:
• The data and power lines must be connected and installed in compliance
with the standards to avoid failures on your installation and eliminate any
danger to personnel.
• For installation, startup, maintenance and repair, please observe the
accident prevention regulations of your machine (e.g., DGUV Regulation
"Electrical Installations and Equipment").
• Emergency stop functions and equipment must not be deactivated or
otherwise made ineffective. See relevant standards (e.g., EN 418).
• Your installation must be equipped in accordance to the EMC guidelines so
electromagnetic interferences can be eliminated.
• Please observe the safety measures against electrostatic discharge
according to EN 61340-5-1/-3. When handling the modules, ensure that
environmental factors (persons, workplace and packing) are well grounded.
• The relevant valid and applicable standards and guidelines regarding the
installation of switch cabinets must be observed.
Pos: 14. 9 /Dok ume ntati on all gem ein/Glie de rung sele ment e/- --Seit enwec hsel- -- @ 3\ mod_ 122 110 804 507 8_0. docx @ 21 810 @ @ 1
Important Notes 11
Manual
1.0.01