Table 33: Wbm Page, "Security" - "Static Sak" Tab - WAGO 852-1322 Manual

852-1322/852-1328 Industrial Managed Switch
The selected port(s) will use the given static SAK as the secure key to secure all
the traffic. If any two switches have the same SCI and SAK, they can securely
communicate. If there is any non-secured traffic that uses incorrect SCI and SAK,
the traffic will be dropped by the ingress port of the switch. The description of the
static SAK setting fields are summarized in Table "WBM Page, "Security" –
"Static SAK" Tab".
To disable the Static SAK setting for any of the port(s), simply select the desired
port(s) from the dropdown list and uncheck the Enabled box. Then click on the
[Submit] button. This will update the status of the setting in the Static SAK
Status table in the lower part of the Figure "WBM Page, "Security" – "Static SAK"
Tab".
Table 33: WBM Page, "Security" – "Static SAK" Tab
Parameters
Port
Enabled
SCI
SAK
Factory Default Description
Option Select specific port form the dropdown list to be configured.
Uncheck Check the box to enable static secure association key (SAK)
mode of MACSec for the selected port(s) on the switch
0 Secure Channel Identifier (SCI) is a 16-digit hexadecimal
number. Note that if the user did not configure all digits of SCI,
all remaining digits will be auto-configured to 0s.
0 Secure Association Key (SAK) is a 32-digit hexadecimal
number. Note that if the user did not configure all digits of
SAK, all remaining digits will be auto-configured to 0s.
Configuration in the WBM 67
Manual
1.0.01