Snmp Trap; Figure 33: Wbm "Diagnostics" Page - "Snmp" Tab, Snmp Trap - WAGO 852-1322 Manual

Managed switch; 8 port gb; macsec/ 6 port gb; 2foc; macsec

Hide thumbs Also See for 852-1322:

Table of Contents

Configuration in the WBM

7.5.1.3

SNMP Trap

The industrial managed switch provides a trap function that allows the switch to

send notification to agents with SNMP traps or inform. The notifications are

based on the status changes of the switch such as link up, link down, warm start,

and cold start. For inform mode, after sending SNMP inform requests, the switch

will resends inform request if it does not receive response within 10 seconds. The

switch will try re-send three times. Figure "WBM "Diagnostics" Page – "SNMP"

Tab, SNMP Trap" shows the SNMP Trap section.

Figure 33: WBM "Diagnostics" Page – "SNMP" Tab, SNMP Trap

The SNMP Trap Mode allows users to configure SNMP Trap mode or Inform

mode by selecting the desired mode from the dropdown list as shown in Figure

WBM "Diagnostics" Page – "SNMP" Tab, SNMP Trap". Then, click [Submit]

button to change the mode. The SNMP Trap Setting shows a list of configured

SNMP Trap Server. Example in Figure "WBM "Diagnostics" Page – "SNMP" Tab,

SNMP Trap" shows an Empty list. The user can enter an IP address in the Trap

server IP field, port number of Trap server in the Port field, and a string used as

Community String for an authentication. After filled in all required field for SNMP

Trap Setting, please click on the [Add] button. Table "WBM "Diagnostics" Page –

"SNMP" Tab, SNMP Trap" summarizes the descriptions of the SNMP Trap

parameters.

Manual

1.0.01

852-1322/852-1328 Industrial Managed Switch

Table of Contents

Table of Contents

852-1328