100/1000Base-Sx/Lx Port, Fiber Optic (Only For Sfp Model) - WAGO 852-1322 Manual

852-1322/852-1328 Industrial Managed Switch
5.2 100/1000Base-SX/LX Port, Fiber Optic (Only for SFP
model)
When connecting a fiber optic cable to a 100/1000Base-X port on the industrial
managed switch, make sure to use the right connector type (LC) and SFP
module.
There are various types of multi-mode, single mode or WDM SFP modules.
Follow the steps below to connect the fiber optic cable properly:
Rubber covers
Remove and safely store the rubber covers of the fiber optic port (LC).
If no fiber optic cable is connected, the rubber cover should be installed to protect
the fiber optics.
1. Insert the respective SFP modules.
2. Ensure that the fiber optic ports are clean. You can clean the cable
connectors by wiping them with a clean cloth or a cotton ball soaked with a
little ethanol. Dirty fiber optic cables affect the quality of the light transmitted
via the cable and leads to reduced performance at the port.
3. Connect one end of the fiber optic cable to the LC port of the industrial
managed switch and the other end to the fiber optic port of the other device.
Proper connection of the fiber optic cable to the SFP module
For a proper connection, snap the connector of the fiber optic cable into the SFP
module audibly.
4. Check the respective port LED on the industrial managed switch that the
connection is established (see Section "Device Description" > ... > "Display
Elements" > ... > "Port LEDs").
Connect Devices 29
Manual
1.0.01