Table of Contents
Advertisement
852-1322/852-1328 Industrial Managed Switch
7
Configuration in the WBM
An internal file system and integrated Webserver can be used for configuration
and administration of the system. Together, they are referred to as the Web-
Based Management (WBM) system.
The HTML pages saved internally provide you with information about the
configuration and status of the industrial managed switch. In addition, you can
also change the configuration of the device here.
Always restart after making changes to the configuration!
The system must always be restarted for the changed configuration settings to
take effect.
7.1
Login
1.
To open the WBM, launch a Web browser (e.g., Microsoft Edge or Mozilla
Firefox or Google Chrome).
2.
Enter the IP address of the device (i.e. WAGO 852-1322 or 852-1328).
Note that the default IP address is 192.168.1.254.
3.
While the device is booting up, it would send the GARP packets to the
network. Therefore, if you use the DHCP protocol to assign the device's IP
address or you forget the static IP address of the device, you could capture
the GARP packets by using Wireshark (a network sniffer software) as
shown Figure "Example of Wireshark software sniffing on IP address of a
switch" in to find the IP address that is assigned to the device.
Figure 10: Example of Wireshark software sniffing on IP address of a switch
4.
Click [Enter] to confirm.
Configuration in the WBM
33
Manual
1.0.01
Advertisement
Chapters
Table of Contents
