4Wd/6Wd Selector - BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual

NOTE: To allow engine starting, the
D.E.S.S. key must be securely installed
on the D.E.S.S. post and the emer-
gency engine stop button set to RUN.
To power up the vehicle without start-
ing the engine, refer to
THE ELECTRICAL SYSTEM
Override/DPS
This button has 2 functions.
vmo2016-022-030_d
TYPICAL
1. Override button
2. Engine start button
Override Function
The override switch main function is to
bypass the engine speed limiter in re-
verse operation by allowing maximum
engine torque.
WARNING
Only use the override to help get
the vehicle unstuck from mud or
other soft terrain. Do not use the
override for normal operation in
reverse. This would allow driving
in reverse at excessive speeds and
can increase the risk of losing con-
trol.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
WAKING UP
WARNING
_______________
To engage the override function, pro-
ceed as follows:
While the shift lever is set to REVERSE
position.
1. Ensure that the vehicle is stopped.
2. Press and hold the override switch
then press the throttle lever gradu-
ally.
NOTE: When using the override func-
tion, the gauge will scroll an OVER-
RIDE message to confirm that the
function is activated.
3. To disengage the override function,
simply release the override switch.
DPS Function
This button is also used to change the
DPS (Dynamic Power Steering) mode.
To change DPS mode, refer to
YOUR RIDE
subsection.

8) 4WD/6WD Selector

The 4WD/6WD selector is located on
the RH side of the handlebar.
sfvmo2014-012-007_a
TYPICAL
1. Selector
2. 4WD position
3. 6WD position
CONTROLS
TUNE
91