Table of Contents
Advertisement
3/8-16 X 3 HEX
HEAD CAP SCREW
HOSE CLAMPS
2110 hitch hose clamps
Hydraulic Installation
NOTE
See Figures 3-8 and 3-9 for wheel lift and coulter lift
hydraulic diagram.
1. Install the manifold to the manifold bracket on the
frame using 1/2-13 x 3-1/2 hex head cap screws and
hex lock nuts.
o
2. Install 90
adapter in port E in the rear of the
manifold.
Figure 3-10: Hitch Hose Clamps and Color Design
ASSEMBLY INSTRUCTIONS
3/8-16 HEX LOCK NUT
3. Install wheel lift and coulter lift system hoses (See
Figures 3-8 and 3-9).
4. Hold each system of hoses in place using 3/8-16 x 3
hex head cap screw, hose clamps, and hex lock nut
(See Figure 3-10.)
5. Install steel plugs in any remaining open manifold or
valve ports.
6. Install hose wraps around system hoses per hose
identification decal near hose couplers, putting both
hoses inside wrap(See Figure 3-10.) Note that no
yellow hose wrap is used on rigid models.
3-17
Advertisement
Table of Contents
