Table of Contents
Advertisement
Figure 2-2. Setting a Logical Address Switch
NOTE
Plug-in modules also contain Interrupt Switches. We recommend that you leave these switches set to 1
(factory setting). This causes the modules to use interrupt line 1 which is the default line for most interrupt
handlers (command module, embedded controller, etc.). Refer to the "C-Size VXIbus Systems Installation
and Getting Started Guide" if you need more information on Interrupt Switches.
Configuration and Wiring 2-3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
