List Of Memory Switches - Brother KE-430F Service Manual

4. FUNCTION SETTINGS

4-4. List of memory switches

NOTE:
In standard memory switch setting mode (refer to the CD Instruction Manual), the bottom two digits only display memory
switch Nos. 00 to 49. The bottom two digits do not display memory switch Nos. 50 to 99.
Work clamp/button clamp settings (001 − 099)
No. Setting range
OFF, 1 − 2
001
051 ON/OFF
052 ON/OFF
0 − 3000
060
(ms)
070 1 − 2
071 1 − 2
072 1 − 5
10
Initial
Setting units
value
Work clamp/button clamp lift timing when sewing is complete
OFF: Does not lift automatically.
1 1
1: Lifts at the final stitch position.
2: Lifts after moving to the sewing start position.
Work clamp/button clamp operation before moving to the sewing start
position
ON: The work clamp/button clamp can operate vertically even before
OFF -
OFF: The work clamp/button clamp cannot operate vertically before
Work clamp/button clamp operation during pause (split program)
ON: The work clamp/button clamp cannot rise automatically during a
OFF -
OFF: The work clamp/button clamp can rise automatically during a
Time after the work clamp/button clamp drops until the upper shaft
0 10
starts rotating
Type of foot switch used
1 1
1: Foot switch
2: 2-pedal foot switch (option)
Foot switch operating mode
* Enabled when No. 070 is set to "1". (Refer to page 22.)
1 1
1: (1st step) Drop
2: (1st step) Drop to intermediate height
2-pedal foot switch operating mode
* Enabled when No. 070 is set to "2". (Refer to page 23.)
1: (Work clamp switch 1st step) Drop, (Start switch) Start
2: (Work clamp switch 1st step) Drop to intermediate height
1 1
3: (While work clamp switch depressed to 1st step) Work clamp/button
4: (Work clamp switch 1st step) Drop
5: (Work clamp switch 1st step) Drop to intermediate height
KE-430F, BE-438F
Setting details
moving to the sewing start position.
moving to the sewing start position.
pause (split program).
pause (split program).
(2nd step) Start
clamp switch 2nd step) Drop, (Start switch) Start
clamp rises, (Start switch) Start
Start
clamp switch 2nd step) Drop and start
(2nd step) Drop and start
(Work
(Work clamp switch 2nd step)
(Work