And Y Parallel Movement Of Sewing Patterns - Brother KE-430F Service Manual

6. X AND Y PARALLEL MOVEMENT OF SEWING
PATTERNS
The work clamp/button clamp can be moved to any desired position so that sewing patterns which have already been
programmed can be moved in parallel directions forward, back or to the left or right.
Use this when you would like to correct the sewing position with respect to the work clamp/button clamp.
1
For example, program
No. 1
2
3
2nd step
4
For example, set to 0.05.
5 Confirm the movement amount.
6. X AND Y PARALLEL MOVEMENT OF SEWING PATTERNS
Press the
* If a cycle program has been selected, the following
operation cannot be carried out. Select a program
from 1 to 999.
2776B
While holding down the TEST key, press the
switch to parallel movement mode.
・ The amount of parallel movement in the horizontal
direction which has currently been set will be
displayed in the menu display in mm units.
* The sewing machine will not switch to parallel
movement mode if memory switch No. 465 is set to
"3".
Set it to "1" or "2".
Depress the foot switch to the 2nd step.
・ Home position detection will be carried out.
・ The pattern number will change to illuminated.
4441Q
Each time the
clamp/button clamp will move by 0.05 mm.
・ In X-scale parallel movement mode, the work
clamp/button clamp will move to the left when the
key is pressed, and to the right when the
pressed.
・ The range of movement is a maximum of -9.95 mm to
+9.95 mm. However, the sewing pattern cannot be
moved outside the sewing area.
2778B
Press the ENTER key.
・ The amount of parallel movement in the horizontal
direction will be confirmed, and the menu display will
change to illuminated.
2414B
KE-430F, BE-438F
or key to select the program number.
or key is pressed, the work
(Continued on next page.)
key to
2777B 2648B
key is
41