Brother KE-430F Service Manual page 89

Tighten the two set screws 19 on
the screw stop while
pressing the collar shaft 17 in the
direction shown in the illustration.
Check that the thread trimmer
collar 16 turns smoothly.
Apply grease.
2833B
15. Driving lever
16. Thread trimmer collar
17. Collar shaft
18. Retaining ring, C
19. Set screws [2 pcs: Tighten]
20. Thread trimmer rod V assembly
21. Shoulder screw B
22. Nut
23. Guide shaft
24. Spring
25. Set screws [2 pcs: Tighten]
26. Shoulder screw B
27. Nut
lightly
28. Plain washer
29. Spring washer
30. Bolt
31. Thread trimmer link
32. Solenoid shaft
33. Set screws [2 pcs: Tighten]
34. Thread trimmer link
35. Washer, wave spring
36. Link shoulder screw
37. Nut
38. Thread trimmer solenoid assembly
39. Bolts [3 pcs]
40. Connecting plate
41. Shoulder screw, 6-1.8
KE-430F, BE-438F
10. ASSEMBLY
Push the thread
trimmer solenoid
assembly 38 downward
gently to install it.
When the ball joint assembly of the
thread trimmer rod V assembly 20
has been disassembled, assemble
it so that the distance between the
centers of the holes is 309.5 ± 0.5
mm.
2834B
2835B
79