Brother KE-430F Service Manual page 107

After applying sealant (Threebond 1215) to the
shaded area, install the gear cover 24 by tightening
the five screws 25 at a torque of 1 Nm.
2875B
Remove the rubber cap (1) and apply grease,
and then reinstall the rubber cap (1).
1) Turn the pulley to set the needle bar to
near its lowest position.
2) Insert the grease nozzle (3) into the
gear box as far as the lower shaft gear
(2), and apply 16g of grease (BZL-500
grease).
16g of grease
KE-430F, BE-438F
10. ASSEMBLY
24. Gear cover
25. Screws [5 pcs]
26. Grease support F
27. Screws [2 pcs]
28. Rubber caps [2 pcs]
(1) Rubber cap
2876B
Insert as far as this
2877B
97