Brother KE-430F Service Manual page 176

16. TABLE OF ERROR CODES
Data editing-related errors
Code
The enlargement ratio setting caused the sewing data to extend outside the sewing area.
E500 Press the RESET key (*1) to clear the error.
Set the enlargement ratio or the sewing area again.
The enlargement ratio caused the data pitch to exceed the maximum pitch of 12.7 mm.
E502 Press the RESET key (*1) to clear the error.
Set the enlargement ratio again.
Error in pattern data.
E510 Press the RESET key (*1) to clear the error.
Re-read the pattern data from the media, or recreate the pattern data.
No end code has been input into pattern data.
E511 Press the RESET key (*1) to clear the error.
Recreate the pattern data containing the end code, or change the pattern number being read.
Number of stitches exceeds allowed maximum.
E512 Press the RESET (*1) key to clear the error.
Change the number of the pattern being read.
Memory switch file cannot be read correctly.
Copy source model and copy destination model are incorrect. (Maybe the 430F is attempting to read data for the
E581 438F.)
Press the RESET key (*1) to clear the error.
Read data for the same sewing machine model.
Memory switch version does not match.
E582 Press the RESET (*1) key to clear the error.
Read data for the same version.
Parameter version does not match.
E583 Press the RESET key (*1) to clear the error.
Read data for the same version.
(*1) If the main PCB version is 1.5.00 or later, press the key or switch which has been set by memory switch No. 650.
Device-related errors
Code
Upper thread breakage occurred.
E600
Press the RESET key (*1) to clear the error.
Thread nipper motor home position cannot be detected. Problem with thread nipper motor or poor thread nipper
encoder connection.
E690
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps.
Check that connector P20 on the main PCB is properly connected.
Thread nipper motor stopped abnormally.
Check if the upper thread trailing length is too long.
E692
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps.
Check that connectors P20 and P4 on the main PCB are properly connected.
(*1) If the main PCB version is 1.5.00 or later, press the key or switch which has been set by memory switch No. 650.
166
Cause and remedy
Cause and remedy
KE-430F, BE-438F