Memory Switches - Brother LZ2-B855E Service Manual
Electronic single needle zigzag lock stitcher
electronic single needle zigzag lock stitcher with thread trimmer
Hide thumbs
Also See for LZ2-B855E:
- Service manual (93 pages) ,
- Specifications (8 pages) ,
- Instruction manual (222 pages)
Table of Contents
Advertisement
8-6. Memory switches
The functions of the switches on the operation panel can be changed to carry out special functions.
TEST
TEST
EZ
EZ 855
S E T
E T
1. Turn on the power, and have the zigzag width displayed.
2. While pressing the TEST key, press the PATTERN key.
d5| will appear on the display.
3. Press the TEST key. 11oor 11O will appear on the display.
The numbers in the hundred's place and ten's place indicate a memory switch number.
o in the one's place indicates that the memory switch is OFF, and O indicates ON.
4. Display the memory switch number that you would like to change.
The numbers are changed with
5. After the memory switch number that you would like to change has appeared, set the number to ON/OFF with
key in the one's place.
6. Press the SET key to accept a setting. d5| will appear on the display.
key in the hundred's place twice. En| will appear on the display.
7. Press the
8. Press the SET key.
The display returns to the normal display.
Contents
No.
01
Parameter setting can be changed. (See Remarks.)
02
The treadle suddenly depressed forward after it has been depressed backward is activated.
03
(Set to OFF)
04
Backtack speed is not limited by the speed setting of high speed-sewing.
05
No torque boosts.
06
No automatic needle through force UP operation
07
(Set to OFF)
08
(Set to OFF)
11
Thread trimming or no thread trimming can be set. (See Remarks.)
12
After thread trimming, the presser foot goes UP (when DSW1-1 is ON).
After thread trimming, the presser foot goes DOWN (when DSW1-1 is OFF).
13
After sewing is stopped at treadle neutral position, the presser foot goes UP.
14
The actuator SW is used as a thread trimming SW.
15
No immediate stop function
16
No overtime function. (See Remarks.)
17
Half stitch correction operation (See Remarks.)
18
Reverse correction operation (See Remarks.)
21
(Set to OFF)
22
(Set to OFF)
23
(Set to OFF)
24
(Set to OFF)
25
(Set to OFF)
26
Before end backtack is sewn, speed does not change from high speed to low speed. (When OFF, speed
increases to backtack speed after deceleration.)
27
(Set to OFF)
28
(Set to OFF)
31
Sewing can be stopped during start backtack sewing.
32
(Set to OFF)
1 2 3 4
5
6
7
8
9
PA
PAT T ERN
ERN
S
S
ROM
L
r
keys.
When ON
LZ2-B855E,B856E
8. ELECTRIC COMPONENTS
TEST
TEST
1154S
8-18
- Quick Links:
- List of Error Codes
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
