Adjusting The Main Shaft Motor Standard Position - Brother KE-430F Service Manual

11-19. Adjusting the main shaft motor standard position

1
Remove the needle, the needle bar thread guide and the feed plate.
2
3
4
5
While pressing the [+ -] keys simultaneously, turn on the
power switch.
・ "Mot" will illuminate in the PROGRAM No. display and
"Set" will illuminate in the menu display.
Turn the pulley one full turn in the direction of the arrow.
・
" UP" will flash in the SECTION No. display and
" dn" will flash in the TENSION display.
* If nothing is displayed, turn the pulley by hand until
the displays appear.
Turn the pulley in the direction of the arrow to lower the
needle bar from its highest position to the height shown in
the illustration at left.
Press the ENTER key.
・
" UP" will illuminate in the SECTION No. display and
" dn" will illuminate in the TENSION display.
* If the displays are still flashing, carry out step 4 once
more.
KE-430F, BE-438F
11. ADJUSTMENT
2811B 2818B
2813B
2814B
2414B 2815B
(Continued on next page.)
123