Trigger Setup - Lyngdorf Audio MP-60 Owner's Manual

Trigger Setup

Trigger In Setup
Allows you to set up the system so that the MP-60 can be switched on by an external device.
The MP-60 will turn on if a voltage above 1.5V is detected.
Trigger Out Setup
Allows you to set up the system so that the MP-60 can control the power state of other devices like amplifiers
and curtains through a simple connection.
Off – No action
Source – When the preset source for any zone is selected, it will trigger. Use source setup menu to
associate the trigger with a source.
Source A – When the preset source for Zone A/Main zone is selected, it will trigger.
Source B - When the preset source for Zone B is selected, it will trigger.
Power A – When Zone A / Main Zone is On, it will trigger
Power B - When Zone B is On, it will trigger
Power any - When any Zone is On, it will trigger
You can set the trigger output to be on/off or as a pulse activation. You can select either a 5V or a 12V
output. (settings menu appears, when a trigger system is activated on a source)
Lyngdorf Audio MP-60 – Owner's manual 27