Verify Speakers; Adjust Sub; Channel Gain - Lyngdorf Audio MP-60 Owner's Manual

Subwoofer options:
Enable or disable this subwoofer by using your mouse.
Gain
In a later process you will be guided through the level settings on your subwoofer. If the settings on the
subwoofer does not allow for full correction, you can increase the level here to match the input sensitivity of
your subwoofer.
Amplifier Delay
If your subwoofer features internal processing, you need to compensate for this by entering the relevant
delay in milli-seconds (ms).

Verify Speakers

This function will allow you to test if the amplifiers and speakers are connected correctly to the outputs of the
MP-60. Follow the directions on the screen.

Adjust Sub

As the subwoofers are handling the bass information from multiple speaker channels, it is essential that the
subwoofer(s) are aligned with each other and with the relevant speaker channels. Without alignment you risk
having an inferior performance due to stress on the subwoofer's internal amplifier.
With one or more active subwoofer(s) connected to the MP-60, this menu will guide you into setting the
volume level on each subwoofer's controls. Follow the instructions on the display to go through two phases:
1. Find the correct system volume to do the Subwoofer adjustment (tones through speakers)
2. Adjust the volume setting on each subwoofer for the RoomPerfect™ calibration.

Channel Gain

This menu will allow you as per your personal preferences to change the level of each speaker, in its
relations to the decoded signal. This means that if you prefer that some surround speakers are higher in
level with DOLBY decoded material only, you can adjust this without affecting the level of the speaker, when
Lyngdorf Audio MP-60 – Owner's manual 20