Lyngdorf Audio MP-60 Owner's Manual page 39

Fault – Low signal
This error message is displayed when the measurement has lasted more than 5 minutes for the low-
frequency signal or more than 2 minutes for the high-frequency signal. This happens most often when using
a low-level measuring signal compared to the background noise in the listening environment, which results in
prolonged measuring times. Raise the measuring signal volume or reduce the noise in the environment
before continuing with the measurement.
If raising the volume does not eliminate the error message, the microphone or cable might be defective. Test
the microphone cable by connecting the microphone directly into the microphone socket and select Retry.
Can´t Turn On Via LAN or Control System
•
The MP-60 needs to be set to Network mode to be able to turn on via a control system. It will not turn on
when in Deep Sleep. This is set up in System Configuration / General Setup/ Power Management
Retrieving and Sending an Error Log
The processor generates a log file, which contains information of all detections and actions made by the
software. To retrieve an error log holding, you need to access the MP-60 via your browser. Under 'Manage
Software' you can download a text file and email it to your Lyngdorf Audio representative.
3D Compatibility Not Detected
If the MP-60 isn´t fully booted, a Blu-ray player will not be able to detect its 3D compatibility.
Restart the player to fix the problem.
Remote Control Doesn´t Work
The remote control is paired to the MP-60 at the factory; you need to pair it again only if you have a new MP-
60 or remote. To pair the RF remote control to a MP-60:
1. Turn on the MP-60.
2. On the remote hold down Play and OK until the remote control´s green LED flashes.
3. Point the remote control at the MP-60 and hold it within 30cm / 1 foot of the front panel; when the
green LED stops blinking, the remote is connected via Zigbee.
4. The remote will be paired to the MP-60.
To switch the remote from RF to IR mode, hold down OK and 1. The LED will flash red twice.
To switch the remote back to RF mode, hold down OK and 2. The LED will flash green twice.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.
Lyngdorf Audio MP-60 – Owner's manual 39