Roomperfect™ Preparations - Lyngdorf Audio MP-60 Owner's Manual

When measuring distances to in-wall woofers:
•
If the stack of woofers is taller than the listening position, measure the distance from the listening
position to the dust cap of the middle of the stack of woofers.
•
If the woofers are lower than the listening position, measure the distance from the listening position to
the top dust cap of the top woofer.
The RoomPerfect™ microphone is a very sensitive and finely calibrated device which
must be treated with utmost care. If the microphone has been dropped on the floor, it
may be damaged. If this is the case, obtain a new microphone from your Lyngdorf Audio
RoomPerfect™ Preparations
•
Place the RoomPerfect
the microphone does not move during a measurement.
•
Plug the supplied microphone cable into the microphone.
•
Connect the microphone cable to the microphone terminal on the rear panel of your processor
Each RoomPerfect™ microphone is calibrated within very small parameters and using a
new microphone does not require adding any calibration file. The microphone does not
work with traditional power supply, and it cannot be replaced by any other microphone
Placing the Microphone in the Focus Position
When you are prompted to place the microphone in the focus position, place the microphone, using the
microphone stand, in your primary listening position. The height and the orientation of the microphone should
correspond to your head's height and direction.
Lyngdorf Audio MP-60 – Owner's manual
representative before performing the system calibration.
TM
calibration microphone on the stand. Be sure to fasten the screws properly so
design.
22