Lyngdorf Audio MP-60 Owner's Manual page 17

Note:
A single (mono) subwoofer must be set as LFE subwoofer – no matter where you position it in the room
Sub Right and Sub Left is used in combination only, as it is used for a stereo setup – but you can activate
both the LFE subwoofer and the Sub Right/Sub Left, which will direct the LFE signal to the dedicated
subwoofer and direct the bass from the speaker channels to the Right and Left subwoofers.
LFE Channel cut-off
LFE (Low Frequencies Effects) is an individual audio channel for bass effects. The LFE channel cut-off will
add a low-pass filter for the signal to this subwoofer. Apart from the standard settings you can create your
custom cut-off setting.
The MP-60 can decode up to 16 channels (including the LFE, Low Frequencies Effects), and the system will
inform you, if you try to activate more speakers than the MP-60 can process – or is trying to make a setup,
which cannot be handled due to the limitations set by Dolby, DTS or Auro. An error message will appear!
The errors could be:
Error trying to activate one or two rear surround speakers without any side surrounds. The initial surround
sound speakers must be a pair of side surround speakers (LS & RS) – no matter where you position them.
Lyngdorf Audio MP-60 – Owner's manual 17