How To Pair Remote Control In Rf Mode; Switching Remote Between Rf And Ir Mode; Getting Started (Details In Following Chapters) - Lyngdorf Audio MP-60 Owner's Manual

How to Pair Remote Control in RF Mode

The MP-60 remote has both an IR and RF mode, and is by default set to IR.
To pair the RF remote control to the MP-60:
1. Turn on the MP-60.
2. Hold down Play/Pause and OK until the remote control´s green LED flashes.
3. Release the buttons.
4. Point the remote control at the MP-60 and hold it within 30cm / 1 foot of the front panel; when the
green LED stops blinking, the remote is connected.
5. The remote is now RF paired to the MP-60.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.

Switching Remote Between RF and IR Mode

To switch the remote from IR to RF mode, hold down OK and 2. The LED will flash green twice.
To switch the remote from RF to IR mode, hold down OK and 1. The LED will flash red twice.
If you press a button on the remote and the red LED at the top turns on, then you are in

Getting Started (details in following chapters)

Setting up the MP-60 surround sound processor requires either a network connection or a HDMI connection
to a screen by following these steps:
1. Connect the speakers to the power amplifiers.
2. Connect all external equipment, audio & video, home automation system, mains power, etc. to the
MP-60.
3. Switch on the MP-60 mains connector on the back and all connected equipment.
4. Turn on the MP-60
5. Access the setup menu via the web interface or press Setup on the remote for having the Menu on
the connected screen.
6. Go to "Speaker and Room" and set the parameters for your speakers.
7. Connect the amplifiers to the correct outputs now specified in the menu
8. Select and press "Verify speakers" to check that speakers and amplifiers are correctly connected.
9. Adjust level(s) on your subwoofer(s) through the feature in the menu, 'Adjust Sub'.
10. Measure and enter the distances to all speakers
11. Run the RoomPerfect™ Guided Setup.
12. Set up sources, audio preferences, stand-by state, zone b, etc.
13. Save and make a backup of the calibration and settings.
Lyngdorf Audio MP-60 – Owner's manual
IR mode. If it turns green you are in RF mode.
10