Table of Contents
Advertisement
Installation Guide Linear Motors
Bearing kit
For fast, uncomplicated maintenance, the linear motors P01-37S-HP-SSCP are equipped with replaceable
slider bearings. The integrated sliding bearings are east to replace in a few manual steps. These plastic
bearings are specially designed for food processing and allow easy wash-down of the stator and slider.
The available bearing set always consists of 2 wiper rings and the front and rear bearing sleeve.
Item
PBS01-37S-B02-SSCP
PBS01-37S-B03-SSCP
5.2.1 Mounting
•
First remove the old wiper rings and the bearing sleeves.
•
The wiper rings can easily be pulled out with pliers. To do this, the bearing sleeves can first be pushed
up with a screwdriver and then pulled out with pliers.
•
Finally, the new bearing sleeves and the wiper rings can be inserted.
Note that the bearing sleeves are damaged when removed and cannot be reused.
Slider mounting kits
5.3.1 Fixed bearing
NTI AG / LinMot
Description
Spare-Bearing Set for PBS01-37S-B02-SSCP
Spare-Bearing Set for PBS01-37S-B03-SSCP
Slider mounting kit consists of a spring washer, a pair of spherical
washers, and a pair of conical seats. It allows the slider to be fixed
in the direction of motion. It also helps to compensate for radial and
angle offset.
P01-37S-HP-SSCP
ENG
Item-No.
0150-4189
0150-4192
Page 17 / 28
Advertisement
Table of Contents
