Advanced Setup - Graco E-Flo iQ Operation Manual

Heat Setup Screen 3
Use the ADM Directional Keypad (CH) to navigate to
Heat screen 3. The Tandem screen is shown below. The
Ram screen is identical except for only having Heat 1 in
the Menu Bar. Make sure you configure these settings
for both Heat 1 and Heat 2 in a Tandem system.
1. Press the soft key to enter editing mode.
2. In the Temp Offset Errors section, set the variance
in degrees allowed from a zone temperature setting
before a deviation and alarm is triggered. The
default values are 15 for deviations and 25 for
alarms. You can enter other temperature values.
For example, if the zone temperature is set at 50
degrees and you set +15 degrees for a High
Deviation and +25 degrees for a High Alarm, the
deviation will occur when the temperature reaches
65 (50 +15) and the alarm will occur when it reaches
75 (50 + 25).
The same applies to the Low Alarm and Low
Deviation settings. In the same example at 50
degrees with a Low Deviation of -15 and a Low
Alarm of -25, the deviation will occur when the
temperature reaches 35 (50-15) and the alarm will
occur when it reaches 25 (50-25).
NOTE: These offsets apply to all of the heat zones in
the Ram or Tandem system.
3. The Heat Idle Timeout feature provides the
capability to deactivate heat after the pump has not
moved for a selected number of hours. Enter the
number of hours in the box provided.
333587B
4. The Drum Size at the bottom of the screen shows
the size of the drum for that ram supply unit. Select
the correct drum size from the two options: 5 Gallon
Drum and 55 Gallon Drum. The correct drum size
must be selected to properly heat the platen.
5. Press the soft key to save your changes and
exit this screen.

Advanced Setup

Use the ADM directional keypad (BH) to change to iQ
Menu screen 2. Press the
Advanced Setup screens. This function allows you to
configure the operating settings for E-Flo iQ system.
Advanced Setup Screen 1
1. Press the soft key to enter editing mode.
2. Select the Language from the drop down menu.
Available languages are English, Spanish, French,
German, traditional Chinese, Japanese, Korean,
Portuguese, Italian, and Russian.
3. Select a Date Format from the drop down menu.
The available formats are mm/dd/yy, dd/mm/yy,
yy/mm/dd.
4. Enter numeric values for the month, day, and
two-digit year in the Date field.
5. Enter numeric values in the Time field for the
24-hour clock in hours and minutes.
6. Enter the number of minutes of inactivity before the
Screen Saver turns off the screen back-lighting.
Enter a 0 to leave it on constantly. Press any key to
disable the screen saver.
Setup
soft key to access the
31