Graco E-Flo iQ Operation Manual page 63

Error Location Type
WBD_ Driver Alarm
WMC_ Driver Alarm
WMH_ Driver Alarm
WMG0 Gateway Alarm
WMN_ Driver Alarm
WNG0 Gateway Alarm
WSC_ Driver Deviation
WSU0 ADM Alarm
WSN_ Driver Alarm
333587B
Error
Error Name Description
Encoder Encoder or hall
Hardware P_ sensor
disconnected or
failed to
commutate
motor
Control Board P_ Control board
reset due to an
exception in
software
Control Board Off The power to
P_ the control
board has been
turned off
Gateway Error Gateway error
Detected detected;
includes any
error not
covered by a
more specific
error
Software Software
Mismatch P_ mismatch
detected in the
motor control
board
Gateway Map Missing or
Error invalid gateway
map
Encoder Encoder
Calibration P_ calibration
information not
found
USB USB
Configuration configuration
Error file not detected
Invalided Styled Style flow rate
setpoint was
invalided when
trying to run
Cause Solution
Encoder Disconnect pump from AC power. Verify
disconnected or encoder cable is properly connected. If so,
faulty replace encoder.
Invalid software Cycle the power to the pump to reset the
state driver software.
Software bug Update software to the latest available on
help.graco.com.
Disconnected Turn on the disconnected switches.
switches
--- ---
Hot board and cold Update the driver control board software to
board have different the latest available on help.graco.com.
software versions
Missing or invalid Install map in gateway.
gateway map
Encoder not Perform encoder calibration through the
calibrated before or setup screens of the ADM.
calibration
information deleted
USB configuration Update software to the latest available on
file not loaded or help.graco.com.
was deleted
The style flow rate Place a desired flow rate in the style
setpoint was zero definitions page.
Troubleshooting
63