Install The Tank Hose - Raven SmarTrax Installation Manual

Disconnect the machine's pressure hose from the steel pressure line.
2.
Pressure Hose Installed
FIGURE 6.
Install a -6 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-069) on the steel pressure line.
3.
Connect the machine's pressure hose to the opposite end of the installed tee fitting.
4.
Install the 90° end of the supplied hydraulic hose (P/N 214-1000-657) on the 90° end of the installed tee
5.
fitting.
Connect the straight end of the installed hydraulic hose to Port P of the SmarTrax valve.
6.

Install the Tank Hose

Locate the machine's steel tank line.
1.
Note:
The pressure line runs on the inside of the frame from the rear of the machine. Trace it to the T
port on the steering orbital if necessary.
Disconnect the machine's tank hose from the steel tank line.
2.
Tank Hose Installed
FIGURE 7.
Install a -8 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-028) on the machine's steel tank line.
3.
Manual No. 016-5032-082 Rev. A
Hydraulic System Installation
13