Centrometal PelTec Series Technical Instructions page 67

5.6.1.3 DELAY
Possible selection:
Factory: 20 sec
Minimimum: 5 sec
Maksimum: 3600 sec
This parameter determines interval of signal repeating.
(This parameter will be ignored if the selected signal is ''continuous'').
In the same way it is possible to adjust the parameters of the output 2 (5.6.2)
5.6.3 TABLE
Factory: Table 1
Table 1, Table 2
This parameter is used to select the predefined table for the alarm. The automatic switching on and
off or changing the signal type at a specific time. It is possible to adjust signal type for speaker and
signal type for low fuel level warning. The table will be operational only if is ''table'' selected in point
5.5.1.1 for output 1 (signal type) or in point 5.5.2.1 for output 2 (signal type).
Technical instructions REGULATION PelTec / PelTec-lambda
Alarm
67