Centrometal PelTec Series Technical Instructions page 61

5.3.4 POWER
Posible selection:
Factory: D6 ~ 100% (maximum power)
Posible selection:
D2 ~ 25% (minimum power)
D3 ~ 45%
D4 ~ 65%
D5 ~ 85%
D6 ~ 100% (maximum power)
This option allows the boiler to work in different powers in order to measure the flue gases in the
boiler modulation phases. The boiler works on the selected power so long as the option is turned
off, or the boiler temperature reach 3°C less than the set maximum temperature of the boiler (in
this case the boiler reduces power). The boiler always achieves a nominal power D6 ~ 100% and
then goes to the selected modulation power.
When is turned ON option "Chimney sweeper":
- external control switches OFF automatically. After turning OFF the
"Chimney sweeper" option, boiler continues to work according to the
requirements of external control. If an external control doesn't request
burner work, then the burner shuts down, otherwise burner will continue to
work.
- boiler shutdown due to grate cleaning option is disabled automatically when
''Chinmey sweeper'' option is enabled.
Technical instructions REGULATION PelTec / PelTec-lambda
IMPORTANT!
Chimney sweeper
61