Centrometal PelTec Series Technical Instructions page 57

5.2.1. FAN
Possible selection:
START 1700 rpm - fan speed must be 1700 rpm
START MAX - fan speed must be on maximun (cca. 2800 rpm)
It is necessary to press the ''START'' next to the corresponding symbols and check if the fan operates
according to the selected option (1700 rpm or cca. 2800 rpm). After pressing the'' STOP'' fan will turn off. Each
time you press'' 'START'' it becomes'' STOP'' and vice versa. The display will rotate the fan symbol and will be
displayed which speed spinning when the option is active.
5.2.2. - 5.2.4. P1, P2, P3
This options enables check of the work the connected pumps or diverter valve (P1, P2, P3).
It is necessary to press the ''START'' next to the corresponding symbol of the adequate pump and check to
see if the pump is running. After pressing the ''STOP'' pump will stop working. Each time you press ''START'' it
becomes ''STOP'' and vice versa. On display will be the symbol of the corresponding pump rotate when the
option is active. Pump marks (P1, P2, P3) depend on the currently selected CONFIGURATION which is
written on the screen.
5.2.5. FLUE GAS CHANNEL CLEANER
This option allows you to check the motor device of flue gas channel cleaner.
It is necessary to press the ''START'' next to the corresponding symbol and check that the motor device of flue
gas channel cleaner will run turbulators. After pressing the ''STOP'', motor device will stop working. Each time
you press ''START'' it becomes ''STOP'' and vice versa. Turbulators symbol is moving on display wen the
option is active.
5.2.6. GRATE CLEANER
This option allows you to check the motor device of grate cleaner.
It is necessary to press the ''START'' next to the corresponding symbol and check that the motor device
moves burner grate. After pressing the ''STOP'' engine will return a burner grate in the work position, the
burner grate is closed (0%). Each time you press ''START'' it becomes ''STOP'' and vice versa. When this
option is active, symbol of burner grate is moving on display. When grate comes in one of two final positions,
the main display shows the symbol "
5.2.7. FEEDER SCREW
This option allows you to check the motor device of feeding screw.
It is necessary to press the ''START'' next to the corresponding symbol and check that the motor device of the
feeding screw is working. After pressing the ''STOP'' engine will stop working. Each time you press ''START'' it
becomes ''STOP'' and vice versa. When the option is active, on display will move a symbol of the pellet
feeding screw and will show animation falling pellet boiler.
5.2.8. ELECTRIC HEATER
This option allows you to check electric heater.
It is necessary to press the ''START'' next to the corresponding symbol and check if the electric heater is
working. After pressing the'' STOP'' electric heater will stop working. Each time you press ''START'' it
becomes ''STOP'' and vice versa. The display will show animation of the electric heater when the option is
active. In this option, when the electric heater is working, then also and fan is working (fan symbol
rotates when the option is active).
Technical instructions REGULATION PelTec / PelTec-lambda
".
Manual test
57