Clear A Fault - Oracle SPARC T5-1B Service Manual

Component name (/SYS/MB/CM0/CMP/BOB6/CH1/D0)
■
Part number (07042208,M393B1K70DH0-YK0)
■
Serial number (00CE0212133341DB80)
■
Use the message ID to obtain more information about this type of fault:
4.
a. Obtain the message ID from console output.
b.
Log into My Oracle Support at:
Search on the message ID.
c.
5. Follow the suggested actions to repair the fault.
If necessary, clear the fault manually.
6.
See "Clear a Fault" on page
Related Information
"PSH Overview" on page 32
■
"Clear a Fault" on page 35
■

Clear a Fault

When PSH detects faults, the faults are logged and displayed on the console. In most cases,
after the fault is repaired, the corrected state is detected by the server module, and the fault
condition is repaired automatically. However, this repair should be verified. In cases where the
fault condition is not automatically cleared, you must clear the fault manually.
1. After replacing a faulty FRU, power on the server module.
2. Determine whether the replaced FRU still shows a faulty state.
See "Check for Faults" on page
If no fault is reported, you do not need to do anything else. Do not perform
■
the subsequent steps.
If a fault is reported, continue to
■
https://support.oracle.com
35.
33.
Step 3.
Clear a Fault
Detecting and Managing Faults 35