Oracle Ilom Service-Related Commands; Related Information - Oracle SPARC T5-1B Service Manual

Log Into Oracle ILOM (Service)
2. If you logged into the CMM, navigate to the server module.
-> cd /Servers/Blades/Blade_n
Replace n with a number that identifies the chassis slot in the modular system where the target
server module is installed.
(Optional) Enable the Oracle ILOM legacy target names.
3.
In current versions of Oracle ILOM, the target names for /SYS, /SP, and /CH are not displayed
by default. Even though the names are not displayed, you can use these target names in
commands at any time. You can also set a property that displays these target names.
Example:
-> set SP/cli legacy_targets=enabled
Set 'legacy_targets' to 'enabled'
Note -
examples and shown in the output examples. For more information, refer to the Oracle ILOM
documentation.

Related Information

"Diagnostics Process" on page 18
■
"Tool Availability" on page 20
■
"Oracle ILOM Service-Related Commands" on page 22
■

Oracle ILOM Service-Related Commands

You can use these Oracle ILOM shell commands when performing service-related tasks.
Oracle ILOM Command
fmadm acquit message_ID
fmadm faulty
help [command]
22 SPARC T5-1B Server Module Service Manual • February 2019
In this manual, the legacy targets (/SYS and /SP) are sometimes used in the command
Description
Manually clears PSH faults.
Note - To run this command in Oracle ILOM, you must start the fault
management shell. See "Clear a Fault" on page
Displays the list of faults detected by PSH.
Note - To run this command in Oracle ILOM, you must start the fault
management shell. See "Check for Faults" on page
Displays a list of all available commands with syntax and descriptions.
Specifying a command name as an option displays help for that command.
35.
33.