Oracle SPARC T5-1B Service Manual page 28

Configuring POST
Parameter
/HOST/diag verbosity
This flowchart illustrates the same set of Oracle ILOM set command variables.
28 SPARC T5-1B Server Module Service Manual • February 2019
Values
power-on-reset
power_on_level
power_on_verbosity
error-reset
error_reset_level
error_reset_verbosity
all-resets
normal
min
max
debug
none
Description
■ debug — Displays extensive debugging information.
■ none —- Disables the output.
Runs POST on every power on.
■ max (default) — Runs the maximum set of tests.
■ min — Runs the minimum set of tests.
■ min (default) — Displays the minimum level of output.
■ max — Displays information for each step.
■ normal —- Displays a moderate amount of information,
including component names and test results.
■ debug — Displays extensive debugging information.
■ none — Disables the output.
(Default) Runs POST if fatal errors are detected.
■ max (default) — Runs the maximum set of tests.
■ min — Runs a minimum set of tests.
■ min (default) — Displays the minimum level of output.
■ max — Displays information for each step.
■ normal — Displays a moderate amount of information,
including component names and test results.
■ debug — Displays extensive debugging information.
■ none — Disables the output.
Runs POST after any reset.
Displays all test and informational messages in POST output.
Displays functional tests with a banner and pinwheel in POST
output.
Displays all test, informational, and some debugging messages
in POST output.
Displays extensive debugging information.
Does not display POST output.