Oracle SPARC T5-1B Service Manual page 97

See "Returning the Server Module to Operation" on page
11. Insert the completed enclosure assembly in the same slot as the original server
module.
See "Returning the Server Module to Operation" on page
12. Start the server module host.
See "Powering On the Host" on page
13. Access Oracle ILOM on the SP.
See "Log Into Oracle ILOM (Service)" on page
If the replacement SP detects that the SP firmware is not compatible with the existing host
firmware, further action is suspended and this message is displayed:
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
version that supports this chassis.
If you see this message, go to
14. Download the system firmware.
Refer to Servers Administration, Updating Firmware and to Oracle ILOM documentation for
instructions.
15. Perform diagnostics to verify the proper operation of the server module.
See "Detecting and Managing Faults" on page
16. Transfer the serial number and product number to the FRUID of the new
enclosure assembly.
This must be done in a special service mode by trained service personnel.
The replacement enclosure assembly does not have a label with the serial number on the
Note -
front of the server module, as was present on the original server module.
17. (Optional) Update any customer database that contains RFID data.
Use the values from the RFID on the new enclosure assembly.
The RFID on the original server module contains different values.
18. Consider your next step:
Transfer Components to the New Enclosure Assembly
102.
21.
Step 14. Otherwise, go to
17.
Servicing the Enclosure Assembly (Motherboard)
99.
99.
Step 15.
97