Switching the PRO6 Control Centre on/off
Switching the PRO6 Control Centre on/off
Carry out the following to switch the PRO6 Control Centre on or off in a safe manner,
observing all WARNINGS and Cautions.
>> To switch on the PRO6 Control Centre
After connecting up the audio cables, carry out the following:
Mains
outlet
1
Mains
plug
1
Plug the three mains cables into the mains power outlets.
2
Observing
instructions" on page 10) of the mains cables into the mains sockets on the rear
of the control centre. (The green LED next to each mains socket will illuminate if
its mains supply is on.)
3
Observing
switching the D.C. POWER switch on. The PRO6 Control Centre will boot up and,
when the default GUI screens are displayed, it is ready for use.
>> To switch off the PRO6 Control Centre
1
Make sure you have saved any shows, scenes or settings you require (see
"Saving your show files to a USB memory stick" on page 103).
2
At the GUI, choose home
3
At the Shutdown ENTIRE system? prompt, click OK.
4
After the shutdown sequence has finished, switch off the D.C. POWER switch
(rear of control centre).
5
Disconnect the mains cables from the rear of the PRO6.
PRO6 Live Audio System
Owner's Manual
Caution (1)!
A minimum of two power supply modules must be supplying power
to the PRO6 Control Centre for correct operation.
Caution (2)!
Before switching on, check that all monitor loudspeaker power
amplifiers are turned off or muted.
2
Caution (1)!
above, plug the Volex connectors (see "Wiring
Caution (2)!
above, apply power to the PRO6 Control Centre by
Preferences
Mains power on/off
LED indicator
Rear of PRO6 Control Centre
Shutdown System.
31
3
Need help?
Do you have a question about the PRO6 and is the answer not in the manual?