Response To Power On, Reset, Operating Mode Change, Block Search - Siemens SINUMERIK 840D Function Manual

M3: Coupled axes
14.4 Electronic gear (EG)
14.4.8

Response to POWER ON, RESET, operating mode change, block search

Function
Mode change
End of part program
Reset
Power On
1) No coupling is active after Power On.
Block search
A search while a coupling is active (EG) is possible under the following supplementary
conditions:
● Simulation is exclusively with setpoint coupling.
● No cross-channel leading axes may be disabled.
● Axis movements for which all real positions are known to the NC.
If it is technically not sensible or not possible to permit the target block for a block search with
calculation or SERUPRO within a part program section with active coupling, this section can be
locked for "continue machining at the contour".
Programming
● IPTRLOCK()
● IPTRUNLOCK()
Further information
Function Manual Basic Functions; Mode group, channel, program operation, reset response,
block search type 5 SERUPRO > Lock program section for continue machining at the contour
480
1)
Behavior regarding electronic gearbox
Coupling state
Is retained
Is retained
Is retained
Is not retained
Function Manual, 06/2019, A5E47437747B AA
Configuration
Is retained
Is retained
Is retained
Is not retained
Axes and spindles