Examples - Siemens SINUMERIK 840D Function Manual

M3: Coupled axes
14.6 Dynamic response of following axis
MD22410 $MC_F_VALUES_ACTIVE_AFTER_RESET (F Function is active even after RESET)
Value
0
1
This response also applies for dynamics offsets set using static synchronized actions. If this is
not the case even when MD22410 = 0, then the IDS synchronized action should trigger a repeat
or continuous writing of the dynamic offset.
Further information
Function Manual Synchronized Actions
14.6.2.2

Examples

Electronic gearbox
Axis 4 is coupled to X via an electronic gearbox coupling. The acceleration capability of the
following axis is limited to 70% of maximum acceleration. The maximum permissible velocity is
limited to 50% of maximum velocity. After POWER ON, the maximum permissible velocity is set
to 100% again.
...
N120 ACCLIMA[AX4]=70
N130 VELOLIMA[AX4]=50
N150 EGON(AX4,"FINE",X,1,2)
N200 VELOLIMA[AX4]=100
...
Master value coupling
Axis 4 is coupled to X via a master value coupling. The acceleration capability of the following
axis is limited to 80% of maximum acceleration.
...
N120 ACCLIMA[AX4]=80
N130 LEADON(AX4,X,2)
...
572
Meaning
The values of VELOLIMA[FA] and ACCLIMA[FA] are set to 100% after RESET.
The last programmed values of VELOLIMA[FA] and ACCLIMA[FA] are also active after
RESET.
; reduced speed
; full speed
; 80%
; Activate coupling
Function Manual, 06/2019, A5E47437747B AA
Axes and spindles